Information about amc engines and their specifications.
Amc 401 rod length.
A 401 with a factory 401 head with guide plates done right and with roller rockers sbf or amc will take a pushrod length of 8 140 8 160.
Amc 360 390 401 rods.
The 70 tall deck amc 390 has a unique piston and rod combo that makes it different from the 68 69 variety.
I do not have current numbers at this time.
All molnar rods are finished in the united states at the molnar technologies shop in michigan.
View this page as large as possible and under high resolution for best results.
K1 amc engine rod sets listed below have the correct amc rod beam offset.
Pin wrist pin size that rod is designed to work with.
It was last produced in 1979.
C c length of rod center to center in inches.
Some folks if anal enough will start slightly off center.
These specifications were produced in the early seventies.
Amc 360 rods 390 rods 401 connecting rods and amc stroker rods.
Getting 500 lb ft and more than 480 horses from an amc 401.
That is 250 off the rocker bosses and the thickness of the guideplate to center the tip of the roller.
These rod sets come complete with 3 8 arp 2000 rod bolts installation instructions and arp moly lube.
But hope to soon.
Engine specific production specifications for 360 401 engines.
C c length of rod center to center in inches.
We have rods available for the amc 360 390 and 401 engines with stock stroke crankshafts and also special amc stroker rods 6 000 inch long for use with either a 2 000 inch or 2 100 inch crankshaft rod journal size as used on many amc stroker cranks.
Like the 390 the 401 s crankshaft and connecting rods are forged steel.
Like the 390 factory recommended overbore is only 0 020 in 0 51 mm but commonly bored by 0 030 in 0 76 mm.
Bore rod big end housing bore diameter in inches.
The 401 has 2 090 inch rod and 2 248 inch main journals which means you can swap the.
These rod sets come complete with 8 rods 7 16 arp 2000 rod bolts installation instructions and assembly lube molnar amc engine rod sets listed below have the correct amc rod beam offset.
Getting 500 lb ft and more than 480 horses from an amc 401.
